£0 
This site is best viewed in Google Chrome, Firefox or Safari. Click here to remove this message.
Magura connecting copper Washer - part H
Use These copper washers (Part H) to fit between parts F & G when fixing into the calipers.. Use 1 washer on each side of the 90º connector. (Part F). So put 1 washer on part H, push through part G, and then add another washer before inserting into the caliper. Use a 5mm Alen Key to tighten, ensure its tight but do not over tighten!! be careful!
Weight: 1g
HCC: 8714949019
Related Products
-
M4 x 52.5mm countersunk bolt - Marine Grade Stainless steel Brake disk to hub bolt - -
Magura 90º Bango cable connector - part F - -
Magura Banjo Cable connector Narrow - part K - -
Brake disk support spacer - fits between the spoke and the disk M4 x10 x 10mm - -
Brake Disk Bolt M4x 62.5mm - Fits PHATLADS hub to Brake Disk Purchased as M4x 70mm cut down to 63cm by hand - -
Magura Brake Calipers & Cables - -
Magura brake cable - 265mm repair length between calipers - -
Magura Bolt used to mount the calipers to the hanger - part D - -
Magura Bolt used to mount the calipers to the hanger - PartC - -
MAGURA P - Lever Handle & Grip - -
Magura Valve bolt - part G - -
Magura Brake service kit - -
Magura Cable connector Wide - part J - -
BRAKE DISKS - 5mm CNC Aluminum SOLID or VENTED to fit 5 spoke TRAMPA Hubs - -
Magura Bolt mounting Spacer MG Stainless Steel - Part B - -
Magura Bleed Bung in Caliper - part I - -
Magura brake cable - 2 Meter service Length -
+44 (0)115 8410006
All images and material on this site not covered by other copyright and not explicitly marked as public domain is © Trampa Boards 2000 - 2024