£0 
This site is best viewed in Google Chrome, Firefox or Safari. Click here to remove this message.
Magura Bolt used to mount the calipers to the hanger - part D
Magura Brake special mounting bolt - used to help fix the Calliper into hanger. Part D is made from Marine Grade Stainless steel and will never rust on you.. Once part C is anchored into the hanger, slip the calliper over part C and push this part D into position.. Part D will sit in the half moon that has been CNC'd into the hanger.. Once part D is in position, place the bolt spacer (part B) over the parts C & D and insert the screw (part A) into C & D. You may need to rest your finger at the back of part D in order to get a purchase when screwing in part A but as soon as this has some resistance it will tighten nicely. Ensure the connection between the callipers and the hangers is very tight! FT
Weight: 8g
HCC: 8714949019
Related Products
-
M4 x 52.5mm countersunk bolt - Marine Grade Stainless steel Brake disk to hub bolt - -
Brake Disk Bolt M4x 62.5mm - Fits PHATLADS hub to Brake Disk Purchased as M4x 70mm cut down to 63cm by hand - -
Magura brake cable - 265mm repair length between calipers - -
MAGURA P - Lever Handle & Grip - -
BRAKE DISKS - 5mm CNC Aluminum SOLID or VENTED to fit 5 spoke TRAMPA Hubs - -
Magura Bolt mounting Spacer MG Stainless Steel - Part B - -
Magura connecting copper Washer - part H - -
Magura Bolt used to mount the calipers to the hanger - PartC - -
Magura brake cable - 2 Meter service Length - -
Magura Banjo Cable connector Narrow - part K - -
Magura Brake Calipers & Cables - -
Magura Bleed Bung in Caliper - part I - -
Magura Cable connector Wide - part J - -
Magura Valve bolt - part G - -
Magura 90º Bango cable connector - part F - -
Brake disk support spacer - fits between the spoke and the disk M4 x10 x 10mm - -
Magura Brake service kit -
+44 (0)115 8410006
All images and material on this site not covered by other copyright and not explicitly marked as public domain is © Trampa Boards 2000 - 2024