£0 
This site is best viewed in Google Chrome, Firefox or Safari. Click here to remove this message.
Magura Bolt used to mount the calipers to the hanger - PartC
Magura Brake special mounting bolt, used to fix Calliper to Hanger. Part C is made from Marine Grade stainless steel and will not rust on you!. This part C screws into the modified hangers and Locks the calipers in position.. As a trick to fix this to the hanger, use an M6 bolt and 2 x M6 nuts to lock into the special part C and then tighten into the Hanger.. Using a 10mm spanner tighten this part into the hanger so its really tight - FT. The brake caliper sits over Part C and with use of parts B, D & A locks the caliper into position ready for use.
Weight: 9g
HCC: 8714949019
Related Products
-
Magura Bolt mounting Spacer MG Stainless Steel - Part B - -
Brake Disk Bolt M4x 62.5mm - Fits PHATLADS hub to Brake Disk Purchased as M4x 70mm cut down to 63cm by hand - -
Magura Brake service kit - -
Magura 90º Bango cable connector - part F - -
Magura Cable connector Wide - part J - -
Magura brake cable - 2 Meter service Length - -
Magura Bolt used to mount the calipers to the hanger - part D - -
Magura Bleed Bung in Caliper - part I - -
MAGURA P - Lever Handle & Grip - -
Magura Brake Calipers & Cables - -
Magura Valve bolt - part G - -
Magura connecting copper Washer - part H - -
M4 x 52.5mm countersunk bolt - Marine Grade Stainless steel Brake disk to hub bolt - -
Magura brake cable - 265mm repair length between calipers - -
Magura Banjo Cable connector Narrow - part K - -
BRAKE DISKS - 5mm CNC Aluminum SOLID or VENTED to fit 5 spoke TRAMPA Hubs - -
Brake disk support spacer - fits between the spoke and the disk M4 x10 x 10mm -
+44 (0)115 8410006
All images and material on this site not covered by other copyright and not explicitly marked as public domain is © Trampa Boards 2000 - 2024