This Bearing Support Spacer fits between the Bearings, alongside the O-Ring when fitting Bearings into a TRAMPA hub when mounting the wheel onto 9.525 & 12mm Axles.
Over time, during the usage of your board, bearings & spacers are put under a lot of force. Ultimately this force has to go somewhere. The Bearings use a Steel ring in their assembly where as the Bearing Support Spacers are made from Aluminum - & when forced against each other the aluminum will lose every time! This is what happens to your spacers between the bearings, & over time the spacers shrink, resulting in an annoying rattle. That's when you fit these spacers!
Wheel support spacers for 9.525mm Axles & Bearing support in Hypa Hubs on 9.525mm (7/16ths) Axles.
They snugly fit between the bearings on 9.525mm Axles & ensure maximum spin rate to the rider.
CNC precision made to ensure accurate fit & maximum performance to bearings.
Only fits 9.525mm or what they call 7/16ths UNC imperial Axles & Trampa Hypa Hubs on 9.525mm axles.
Spacer Inner Diameter = 9.525mm
Spacer Outer Diameter = 13.525mm
Spacer Length = 18.2mm
This spacer will not fit between the bearings of the Superstar wheel because of tolerance issues in the accuracy of the spokes for the superstar hubs - for the Superstar hubs you need 17.8mm spacers