£0 
This site is best viewed in Google Chrome, Firefox or Safari. Click here to remove this message.
Wheel Support spacers for Hypa Hub on 9.525mm axles - 9.525mm (ID) x 13.525mm (OD) x 18.2mm x2
This Bearing Support Spacer fits between the Bearings, alongside the O-Ring when fitting Bearings into a TRAMPA hub when mounting the wheel onto 9.525 & 12mm Axles.
Over time, during the usage of your board, bearings & spacers are put under a lot of force. Ultimately this force has to go somewhere. The Bearings use a Steel ring in their assembly where as the Bearing Support Spacers are made from Aluminum - & when forced against each other the aluminum will lose every time! This is what happens to your spacers between the bearings, & over time the spacers shrink, resulting in an annoying rattle. That's when you fit these spacers!
9.525mm (id) x 13.525mm (od) x 18.2mm (long)
They snugly fit between the bearings & ensure maximum spin rate to the rider.
Precision made to ensure accurate fit & maximum performance to x
Only fits 9.525mm (7/16ths imperial) Truck Axles & Hypa Hubs on 9.525mm Axles
Spacer Inner Diameter = 9.525mm
Spacer Outer Diameter = 13.525mm
Spacer Length = 18.2mm
This spacer will not fit between the bearings of the Superstar wheel because of tolerance issues in the accuracy of the spokes for the superstar hubs - for the Superstar hubs you need 17.8mm spacers
Weight: 3g
HCC: 8714929000
Related Products
+44 (0)115 8410006
All images and material on this site not covered by other copyright and not explicitly marked as public domain is © Trampa Boards 2000 - 2024