£0 
This site is best viewed in Google Chrome, Firefox or Safari. Click here to remove this message.
Go Kart Wheel Adaptor plate
Adapts Trampa drivetrains for use on Go-Kart hubs using the standard 58mm PCD bolt pattern.
This adapter plate fits to a Kart Hub Spacer which acounts for offset of the hub and keeps the hub supported on the axle.
Additional 8mm Spacers are availible to fine tune the offset of the hub.
Adapts Trampa drivetrains for use on Go-Kart hubs using the standard 58mm PCD bolt pattern.
This adapter plate fits to a Kart Hub Spacer which acounts for offset of the hub and keeps the hub supported on the axle.
Additional 8mm Spacers are availible to fine tune the offset of the hub.
Weight: 110g
HCC: 95030090
Related Products
-
M8 Rose Jointed Rod End - RIGHT - -
M8 Rose Jointed Rod End - LEFT - -
Go Kart Seat Padding - -
Kart Wheel Large Spacer 22mm - Bearing Housing - -
Kart Wheel Small Spacer - 8mm - -
IGUS 20mm Flange Bearing - -
Throttle / Brake Pedals - -
Steering Knuckle with Bearing Support - -
M8 Tie Rod 200 -240mm Galvanised Steel - -
Go Kart Premium Black Plastic X-Large Xl Racing Seat Karting Racing Race - -
Steering U- Bracket fits M10 Coach Bolt - Mild Steel - -
Steering Shaft Support Plate - -
M8 Tie Rod NUT - LEFT Thread - -
M10 x 65mm Coach Bolt Zinc plated - -
Go-Kart Steering Wheel - -
25x25x2.5mm - DIRT-E-KART Steering Knuckle Arm SCALLOPED to be welded to the Steering Tube - -
M8 Tie Rod NUT - RIGHT Thread - -
Go-Kart Floor Sheet - -
Go-Kart Steering Boss - -
Steering Shaft Plate -
+44 (0)115 8410006
All images and material on this site not covered by other copyright and not explicitly marked as public domain is © Trampa Boards 2000 - 2024