Home»Accessories»WHEELS Accessories & TYRE kits»Bearing Sets»Bearing conversion spacers »8x 10mm Bearing Reducer

These clever reducer sleeves fit inside the TRAMPA bearings and reduce the axle size they fit too from 12mm to 10mm, (most skate trucks have 10mm axles) which is excellent news for 10mm axle riders as they no longer have to fork out the extra money to pay for the special reducer bearing which scrub used to sell.

Due to the accurate fitting of the TRAMPA reducer sleeve into the bearing, when the stainless steel half nut holding the hub onto the axle is tightened up too the bearing reducer sleeve, the sleeve works in perfect harmony with the bearing casing, holding it firmly in a precise position on the truck, ensuring a good spin rate from the bearing and giving maximum performance for the rider.

Bearing conversion Spacer converts 12mm Bearings to fit 10mm Scooters

Use this handy little part to convert 12mm TRAMPA bearings to fit onto 10mm Axles... You will commonly find 10mm axles on Dirt Scooters. Phase 2, Royal, Blunt etc... Using this little part will allow you to fit TRAMPA wheels to 10mm axle Dirt Scooters. Simply slip the spacer into your 12mm Bearing & then insert the wheel back into the Frame... Couldnt be easier.... :-)

The pressed aluminium is accurately made so it fits snugly into your bearing and tightly slides over the axle. The flanged Rim allows the axle nut to tighten without squashing the bearing wall, ensuring free spinning maximum performance from your bearings at all times. The sleeve can be re used over and over again but remember to replace your bearings regularly....