This site is best viewed in Google Chrome, Firefox or Safari. Click here to remove this message.
Mk II MASSIVE Monster Box BASE for 4WD
The Massive Monsterbox Base connects to all vertical panels in a Massive Monster Box or Double Stack Massive Monster Box. They are used with grommets to allow entry into the box by the phase and sensor cables, and the edges of the box are where the hex spacers mount. Additionally, the base is where any Monsterbox is mounted to the board. In this case that can be done via the standard bushing system or Dogbone mounting system. This panel is designed to operate with 4 motors.
The Massive Monsterbox MkV Lid rests on top of the side and end panels of the Massive Monsterbox MkV and centers the screws into the hex spacers to hold the box together.
Mk II MASSIVE Monster Box SIDE PANEL - BLANK LI-PO
The side panel is a structural component of the Massive Monster Box that connects the lids and base of the box together.
Mk II MASSIVE Monster Box SIDE PANEL - CHARGER LI-PO
The Charging side panel is a structural component of the Massive Monster Box that connects the lids and base of the box together. It has cutouts for easy charging and an On/Off Switch.
Mk II MASSIVE Monster Box 2mm END PANEL - LI-PO
Structural component, like the side panels, to connect the lids and base of a Massive Monster Box together.
Mk II MASSIVE Monster Box 2x HD-60T 2mm Mounting Panel (4WD) LI-PO
Used for mounting 2x HD60T on the inside of a Massive Monster Box.